Campbell-scientific WINDSONIC 2-D Sonic Wind Sensors Uživatelský manuál stáhnout pdf (Strana 31)

WindSonic Two-Dimensional Sonic Anemometer

• To activate the SDI-12 Transparent Mode, on Control Port p, enter pX and

press the <enter> key. The datalogger will respond with “entering SDI-

12”. If any invalid SDI-12 command is issued, the datalogger will exit the

SDI-12 Transparent Mode.

• To query the WindSonic4 for its current SDI-12 address, enter the

command ?!. The WindSonic4 will respond with the current SDI-12

address.

• To change the SDI-12 address, enter the command aAb!; where a is the

current address from the above step and b is the new address. The

WindSonic4 will change its address and the datalogger will exit the SDI-

12 Transparent Mode.

• To activate the SDI-12 Transparent Mode on Control Port p, enter pX and

press the <enter> key. Verify the new SDI-12 address by entering the “?!”

command. The WindSonic4 will respond with the new address.

• To exit the SDI-12 Transparent Mode, enter ∗.

FIGURE 7-1. SDI-12 Transparent Mode on an Edlog array-based

datalogger (CR10X) using control port 8 and changing the SDI-12

address from 0 to 1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 45 46

Žádné komentáře

Campbell-scientific WINDSONIC 2-D Sonic Wind Sensors Uživatelský manuál Strana 31