Campbell-scientific CS135 Lidar Ceilometer Uživatelský manuál stáhnout pdf (Strana 67)

User Guide

7.4 Removing the Enclosure Lid

In some circumstances it may be necessary to remove the lid covering the

electronics unit, for example to replace desiccant or carry out a hardware reset.

This is accomplished by removing the four screws as shown in Fig 7.2.

Fig 7.2 Removing the Enclosure Lid

Opening enclosure lid MUST be carried out by a

competent person

Removing the enclosure lid may expose hot surfaces

The unit will still be powered by the battery even if the mains is

disconnected.

Do not use any grease or oil on any seals including the enclosure lid

gasket. The silicone rubber seals used throughout the CS135 can be

damaged by some mineral oils.

WARNING

NOTE

1 2 ... 62 63 64 65 66 67 68 69 70

Žádné komentáře

Campbell-scientific CS135 Lidar Ceilometer Uživatelský manuál Strana 67