Campbell-scientific SDM-CD16S 16-Channel Solid State DC Relay Controll Uživatelský manuál stáhnout pdf (Strana 11)

SDM-CD16S 16 Channel Solid State DC Control Module

TABLE 2. Switch Position and Addresses

Switch

Setting

Base 10 Address

CRBasic Dataloggers

Base 4 Address

Edlog Dataloggers

0 0 00

1 1 01

2 2 02

3 3 03

4 4 10

5 5 11

6 6 12

7 7 13

8 8 20

9 9 21

A 10 22

B 11 23

C 12 30

D 13 31

E 14 32

F 15 33

6. Datalogger Instructions

6.1 CRBasic Dataloggers (CR800, CR850, CR1000, CR3000,

CR5000, CR9000(X))

The SDMCD16AC instruction is used to control all versions of the SDM-

CD16.

SDMCD16AC (Source, Reps, SDMAddress)

Remarks

A port on an SDM-CD16AC is enabled/disabled (turned on or off) by sending

a value to it using the SDMCD16AC instruction. A non-zero value will enable

the port; a zero value disables it. The values to be sent to the SDM-CD16AC

are held in the Source array.

The SDMCD16AC instruction has the following parameters:

Source The Source parameter is an array (dimensioned as Float,

Long, or Boolean) which holds the values that will be sent to

the SDM-CD16AC to enable/disable its ports. An SDM-

CD16AC has 16 ports; therefore, in most instances the

source array should be dimensioned to 16 times the number

of Repetitions (the number of SDM-CD16AC devices to be

controlled). As an example, with the array CDCtrl(32), the

value held in CDCtrl(1) will be sent to port 1, the value held

in CDCtrl(2) will be sent to port 2, etc. The value held in

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Komentáře k této Příručce

Žádné komentáře

Campbell-scientific SDM-CD16S 16-Channel Solid State DC Relay Controll Uživatelský manuál Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Hardware Campbell-scientific SDM-CD16S 16-Channel Solid State DC Relay Controll