Campbell-scientific NL200/NL201 Network Link Interface Uživatelský manuál stáhnout pdf (Strana 12)

NL200/201 Network Link Interface

3.1 Physical Setup

Using the supplied serial cable, connect the NL201’s CS I/O port to the

datalogger’s CS I/O port. Alternatively, power the NL200 or NL201 through

the barrel-connector jack located on the edge of the device. Connect the

NL200/201 to your network using an Ethernet cable, attaching one end of the

cable to the NL200/201’s Ethernet port and the other end to your network.

Ensure that the device is powered up by inspecting the Power LED.

FIGURE 3-1. NL200 with CR800 (external power)

FIGURE 3-2. NL201 with CR800 (powered by datalogger)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Žádné komentáře

Campbell-scientific NL200/NL201 Network Link Interface Uživatelský manuál Strana 12