Campbell-scientific HUB-SDM5 Junction Box for SDMs Uživatelský manuál

INSTRUCTION MANUALHUB-SDM57/04Copyright (c) 2004Campbell Scientific, Inc.

Campbell Scientific CompaniesCampbell Scientific, Inc. (CSI)815 West 1800 NorthLogan, Utah 84321UNITED [email protected]

Warranty and Assistance The HUB-SDM5 is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use a

HUB-SDM5 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab

This is a blank page.

1HUB-SDM51. IntroductionThe HUB-SDM5 is a junction box and is used to connect multipleSynchronous Device for Measurement (SDM) or SDI-12 devices/peri

HUB-SDM52screwdriver into the square slot located next to the circular wire port until itbottoms out. For the cluster of four wire ports located on t

HUB-SDM53FIGURE 2. HUB-SDM5 terminal strip connecting four SDM devices to a datalogger.4.2 Wiring SDI-12 DevicesBefore connecting the SDI-12 signal/

HUB-SDM54FIGURE 4. HUB-SDM5 terminal strip with SDI-12 devicesconnected to a datalogger.5. Generic Junction BoxThe HUB-SDM5 can be used as a generic

This is a blank page.