Campbell-scientific TD Operating System Addendum for CR510, CR10X, and Uživatelský manuál stáhnout pdf (Strana 29)

AD-3-1

SECTION 3. INSTRUCTION SET BASICS

Section 3.7.1 does not apply to the TD operating system which does not use Output Flag 0.

Table 3.8-1 Valid Flag Commands are 11 – 19 to set high and 21- 29 to set low. Because the TD

operating system does not use Fl

ag 0, Commands 10 and 20 are not valid with the TD operating system.

The following table replaces Table 3.10-1 for the TD operati

ng system.

TABLE 3.10-1. Error Codes

Code Type Description

03 Editor Program table full

04 Compile Intermediate Storage full

05 Compile Storage Area #2 not

alloca

ted

08 Run Time CR10X reset by

watc

hdog timer

09 Run Time Insufficient Input Storage

10 Run Time Low Battery Voltage

11 Editor Attempt to allocate more

Input or Inter

mediate

Storage than is available

20 Compile SUBROUTINE encountered

bef

e END of previous

subroutine

21 Compile END without IF, LOOP or

SUBRO

TINE

22 Compile Missing END

23 Compile Nonexistent

SUBROU

TINE

24 Compile ELSE in SUBROUTINE

thout IF

25 Compile ELSE without IF

26 Compile EXIT LOOP without

LOOP

Compile IF CASE without BEGIN

CASE

28 Compile At compile time, no

output s

pec

ified after P84

or unable to automatically

allocate at least one

record per P84

29 Compile Output table requests

e memory than

available

30 Compile IF and/or LOOP nested

too deep

31 Run Time SUBROUTINES nested

too deep

32 Compile Instruction 3 and interrupt

ubr

outine use same port

33 Compile Cannot use Control Port

6 as c

ounter or interrupt

subroutine with

Instruction 15 or SDM or

SDI-12 input/output

40 Editor Instruction does not exist

41 Editor Incorrect execution

inter

43 Compile Time in Instruction 84 or

92 is not a m

ultiple of

execution interval (note:

time is in seconds)

44 Compile Loop (P87) cannot

ontain Data T

able (P84)

60 Compile Insufficient Input Storage

61 Compile Burst Measurement Scan

Rate too shor

62 Compile N<2 in FFT

68 Compile Instruction 118 without

enough Inst

ructions 68 or 63

80 Compile Illegal Interval in P193

81 Compile Illegal Node ID in P193

82 Compile Illegal Reps in P193

92 Compile Instruction 92, intervals in

sec

onds: Time into Interval

> 59 or Interval > 60

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 61 62

Komentáře k této Příručce

Žádné komentáře

Campbell-scientific TD Operating System Addendum for CR510, CR10X, and Uživatelský manuál Strana 29

Komentáře k této Příručce

Související produkty a manuály pro Software Campbell-scientific TD Operating System Addendum for CR510, CR10X, and