Campbell-scientific PakBus Networking Guide Uživatelský manuál stáhnout pdf (Strana 17)

PakBus Networking Guide

Since the preferred method of entering PakBus settings is with Device

Configuration Utility, the next section describes some of the settings and

choices available for these dataloggers.

Open the Device Configuration Utility software and connect to the datalogger.

Once a connection is established, the PakBus settings for the datalogger can be

adjusted.

Under the Deployment tab of the Device Configuration Utility, enter the

PakBus address of the device in the space specified in Device Configuration

Utility. Each PakBus device in the network must have a unique address.

Allowed neighbor lists can be activated by selecting the communication port,

entering a Verify Interval, and choosing a range of addresses that this device

will consider a neighbor. If the allowed neighbor list is activated, the device

will ignore other devices in the network that have an address less than 4000

and are outside the range specified in the list.

There are no other PakBus settings to adjust with the Device Configuration

Utility for these dataloggers.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Žádné komentáře

Campbell-scientific PakBus Networking Guide Uživatelský manuál Strana 17