Campbell-scientific DSP4 Heads Up Display Uživatelský manuál Strana 1

INSTRUCTION MANUALDSP4 Heads Up DisplayRevision: 2/99Copyright (c) 1984-1999Campbell Scientific, Inc.

DSP4 HEADS UP DISPLAY63.10 DSP4 RESET AND MEMORY BACKUP3.10.1 BACKUP FROM OPERATINGDATALOGGERThe DSP4 retains its datalogger program andassociated l

A-1APPENDIX A. CHANGING PROM OR RAM CHIPSThe DSP4 has 5 sockets for memory chips. Two sockets hold 8 K Random Access Memory (RAM)chips and two hold

This is a blank page.

Campbell Scientific CompaniesCampbell Scientific, Inc. (CSI)815 West 1800 NorthLogan, Utah 84321UNITED [email protected]

Warranty and AssistanceThe DSP4 HEADS-UP DISPLAY is warranted by CAMPBELLSCIENTIFIC, INC. to be free from defects in materials and workmanship underno

DSP4 HEADS UP DISPLAYTABLE OF CONTENTSPDF viewers note: These page numbers refer to the printed version of this document. Usethe Adobe Acrobat® book

This is a blank page.

1DSP4 HEADS UP DISPLAY1. INTRODUCTION1.1 SPECIFICATIONSPower Requirement: 10.0 to 15.6 VDC at 1AMPOperating Range: -40 to +80°C standardDimensions:

DSP4 HEADS UP DISPLAY22. PREPARATION2.1 INSTALLATIONWhen installing the DSP4, use the 1/4x20x1/3"mounting bracket screw holes on both sidepanel

DSP4 HEADS UP DISPLAY3Momentarily pressing the UP or DOWN keycauses a single location change.NOTE: If either key is pushed for longerthan 1/3 of a se

DSP4 HEADS UP DISPLAY4minutes.) After completing the programming,press the DSP4 SELECT key to call thedatalogger and restore the COMMAND menu.3.4.2

DSP4 HEADS UP DISPLAY5becomes transparent; the remote operator seesonly the datalogger responses. The DSP4 doeshowever, show all the telecommunicatio