Campbell-scientific SC100 1-Channel Serial Data Interface Uživatelský manuál

SC100 ISOLATED RS-232 BAUD RATECONVERTER INTERFACEINSTRUCTION MANUALREVISION: 8/96COPYRIGHT (c) 1993-1996 CAMPBELL SCIENTIFIC, INC.

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE835: P30 Z=F01: 13 F termination character ( carriage return)02: 00 Exponent of 1003: 24 Z Loc :37:

WARRANTY AND ASSISTANCEThe SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE is warranted by CAMPBELLSCIENTIFIC, INC. to be free from defects in mat

1SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACEThe SC100 interface is an updated version ofthe SC7638 interface. The device has signaland power

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE2Command to enter transparent mode:ctrl-Q(17), I (73), S (83)Command to exit transparent mode:eithe

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE3Parameters Port FunctionConfigurationnumber3 6 8 DTR CTS TX RX 1. DTR, RX 1 0 NZ C NC NC C+1 2

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE4On board jumper setting4321 Modes0000 Burst Mode0010 P15, 9600, Half, None0100 P15, 9600,Full,None

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE5Example of how to configure the SC100 to set up baud rate, parity and error detection03: P91 If Fl

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE614: P30 Z=F01: 17 F command character (ctrl Q)02: 00 Exponent of 1003: 10 Z Loc :15: P30 Z=F01: 73

SC100 ISOLATED RS-232 BAUD RATE CONVERTER INTERFACE702: 00 Exponent of 1003: 13 Z Loc :25: P30 Z=F01: 69 F search byte 2 (E)02: 00 Exponent of 1003: 1